Typical values from 110 sampled wells in Gilchrist County · Full groundwater profile
What Are You Noticing in Your Water?
Pre-selected from Gilchrist County well data. Untick anything you do not notice in your own water.
Based on the contaminants most commonly reported in this region. Always confirm with a certified lab water test before buying equipment.
Explore Florida Interactive Map
Explore Gilchrist County and nearby counties
Gilchrist County has one of the highest rates of private well reliance in North Central Florida, with 80.0% of built parcels drawing drinking water from an onsite well rather than a public utility, according to the Florida Department of Health.
Gilchrist County is one of Florida’s youngest counties, home to the spring-fed Santa Fe and Suwannee Rivers, and like the rest of this region, its groundwater comes from the Floridan Aquifer, a limestone formation that shapes which well water problems show up most often here.
In this guide
Groundwater Profile: Gilchrist County
Most groundwater pumped in Gilchrist County comes from the Floridan Aquifer (USGS, 2015 withdrawals). Across 110 sampled wells, the median hardness is 12.2 gpg, which the USGS classes as very hard. It applies to wells across Gilchrist County, including around Trenton, Bell and Fanning Springs.
What shows up in local well samples:
- HardnessMedian 12.2 gpg; 82% of 110 sampled wells above 7 gpg
Calcium and magnesium dissolved from limestone. Leaves scale on fixtures and water heaters and reduces soap lather. Not a health risk.
Water softener sizing
Hydrogen sulfide (the rotten-egg smell) was measured in only 0 Gilchrist County wells, too few to say how common it is. Limited local data (fewer than 20 samples): individual well testing recommended. If you notice the smell, a sulfide test confirms it.
How Gilchrist County Compares to Florida and the U.S.
See How Gilchrist County Compares to Florida & the US
| Share of wells with… | Gilchrist CountyGilchrist | FloridaFL | United StatesUS |
|---|---|---|---|
| Hard water (above 7 gpg) | 82% | 79% | 60% |
| Iron above 0.3 mg/L | 38% | 35% | 19% |
| Manganese above 0.05 mg/L | 8% | 8% | 21% |
| Dissolved solids above 500 mg/L | 5% | 22% | 15% |
| Acidic water (pH below 6.5) | 4% | 15% | 14% |
| Nitrate above 10 mg/L (EPA limit) | Limited data | 2% | 4% |
| Arsenic above 10 µg/L (EPA limit) | 7% | 3% | 7% |
| Median hardness | 12.2 gpg | 12.4 gpg | — |
| Median pH | 7.2 | 7.2 | 7.3 |
Gilchrist County and Florida: share of sampled wells (all well types, samples since 2000) whose typical value exceeds the level, from the Water Quality Portal. United States: USGS Circular 1332, about 2,100 domestic wells in 48 states sampled 1991 to 2004. Well types and years differ, so read this as a broad comparison. Highlighted cells are well above the national share.
See what a typical Gilchrist County well needs
Opens the diagnostic calculator with Gilchrist County median values (12.2 gpg hardness, 0.15 ppm iron, pH 7.2) for a 3–4 person home. Swap in your own lab results for an exact plan.
Testing Your Well in Gilchrist County
The Florida Department of Health in Gilchrist County oversees private well permitting in the county and investigates suspected contamination. For routine bacteria, nitrate or full-panel tests, use a laboratory certified by the Florida Department of Health.
What to test for in Gilchrist County:
- Bacteria (total coliform and E. coli) and nitrate, at least once a year (Florida Department of Health recommendation)
- Hardness in grains per gallon (gpg) to size a softener
- After any flood, new well work or a change in taste, color or smell
The Florida Department of Health in Gilchrist County can explain how to collect samples and where to send them. Statewide guidance is on the FDOH private well testing page, and our guide to how to test well water covers which tests to order.
Nearby Counties
Gilchrist County borders these counties with published reports:
Frequently Asked Questions
How hard is well water in Gilchrist County?
Groundwater samples from 110 wells in Gilchrist County have a median hardness of 12.2 grains per gallon (208 mg/L), which the USGS classes as very hard. About 82% of sampled wells are above 7 gpg, the point where a water softener is usually worthwhile. The Florida statewide median is 12.4 gpg.
Is iron a problem in Gilchrist County well water?
The median iron level across 72 sampled wells is 0.15 mg/L, below the EPA aesthetic guideline of 0.3 mg/L, and 38% of wells exceed it. Most wells will not stain, but if yours does, a lab test tells you whether iron or manganese is the cause.
Why does my well water smell like rotten eggs in Gilchrist County?
Hydrogen sulfide (the rotten-egg smell) was measured in only 0 Gilchrist County wells, too few to say how common it is. Limited local data (fewer than 20 samples): individual well testing recommended. If you notice the smell, a sulfide test confirms it. The smell is a nuisance rather than a health risk at typical levels.
Which aquifer supplies wells in Gilchrist County?
Most groundwater pumped in Gilchrist County comes from the Floridan Aquifer (USGS, 2015 withdrawals).
Does boiling well water make it safe to drink in Gilchrist County?
Only if bacteria are the problem. A one-minute rolling boil kills germs, but it does not remove nitrate, arsenic or other chemicals, and it concentrates them as water evaporates. Test first, and see our boiling well water myth buster for when boiling helps.
Why does Gilchrist County have so many private wells?
Rural counties like Gilchrist often fall outside the service area of any municipal water utility, so new homes are built with an onsite well by default. The Florida Department of Health’s 2022 parcel mapping found 80.0% of built parcels here on private wells.
Do I need to test my well water if my neighbors say theirs is fine?
Yes. Well depth, casing condition, and the exact aquifer layer tapped can vary block to block, so one neighbor’s clean test does not guarantee another’s. A full annual test is the only reliable way to know what is in your own water.
Is Floridan Aquifer water generally safe to drink untreated?
Much of it is chemically safe but aesthetically unpleasant (hard, sulfur-smelling, or iron-stained), which is why treatment here is usually about comfort and plumbing protection rather than an acute health risk. A lab test is still the only way to rule out bacteria, nitrates, or other contaminants specific to your well.
Written by Well Water Advisor Editorial Team.